Jaw – Jaw

9 Turnbuckles jaw jaw

  1. Turnbuckles are rated with full thread engagement. Use caution to insure proper installation.
  2. “Rated Capacity” refers to a straight (zero degree) pull. Pulling at an angle can reduce the rated capacity significantly.
  3. Meets specification FF-T791b, Type 1, Form 1 – Class 7.
  4. Jaw ends through 5/8″ use nut and bolt, sizes 3/4″ and up use clevis/cotter pins for containment.
  5. Open length estimated dependent on amount of full thread engagement at installation before take-up step.


Design: Jaw / Jaw   Material:
1045 Carbon Steel
Hot Dipped Galvanized
Note: Smaller sizes may be electrogalvanized for better thread fit.